Linear garage door openers can be programmed to open and close with the use of a keypad located outside the garage or a remote control. When using the keypad, the user enters a programmed code to control the door. The remote control has a special code that is linked to the garage door opener once it is programmed. You can program several remote controls to work with one garage door.
Instructions
Keypad Programming
1. Write down a one to six digit pass code you want to use to unlock the door. You only have 15 seconds to enter the code. Writing it down ahead of time will help you program the code in time.
2. Press the Learn button on the garage door opener operator control housing. The operator control housing is mounted on your garage wall.
3. Enter the code by pressing the numbers on the keypad and pushing the Start/Stop button. The light on the motor control unit attached to the ceiling will blink one time as an indication that the keypad is programmed.
4. Test the code by closing the garage door and entering the combination into the keypad. If the door opens, the code was entered successfully. If it doesn't open, repeat Steps 2 and 3.
Remote Control
5. Activate the programming mode on the garage door opener operator control housing by pressing the Learn button.
6. Press the button on the remote control you want to operate the garage door. The motor control unit light will blink once.
7. Test the remote control by pressing the button you programmed. If it does not control the door, repeat Steps 1-2.
8. Repeat Steps 1-3 on any additional remote controls you want to program. The remote controls must be programmed one at a time.
Related Posts:
Change The Code On A Phantom Garage Door Opener
Change the Code on a Phantom Garage Door OpenerThe Phantom garage door opener by Overhead Door, uses a push button to quickly program remotes and keypads. When you lose a remote control, or feel t...
Program A Remote For A Genie 1/2 Hp Garage Door Opener
The Genie 1/2 HP garage door opener is a heavy duty opener. When replacing the remote controls, the new remotes require programming. Programming the remote for a Genie 1/2 HP garage door opener is...
Program An Old Genie Garage Door Opener
Older model Genie garage door openers use dip switches rather than a smart to program the opener and remote controls. Unlike their Intellicode system, which you can program with a press of a butto...
Program My Keypad For My Wayne Dalton Garage Door
Program My Keypad for My Wayne Dalton Garage DoorWayne Dalton has been manufacturing residential garage doors and garage door openers for nearly 60 years. Wayne Dalton also offers electronic wirel...
Sears Craftsman Garage Door Opener Troubleshooting
Save money on repairs by troubleshooting your Sears Craftsman garage door opener first.Sears Craftsman automatic garage door openers rely on several moving parts to raise and lower the door on com...
