The 2002 Buick LeSabre is equipped with a keyless remote that allows the driver to lock and unlock the car, access the trunk and operate a panic alarm all from a hundred to two hundred feet away from the car. Programming a new keyless remote to work with the LeSabre is easy and only takes a few simple steps. There is no complex programming and all that is needed is the remote, an electrical jumper wire and the remote.
Instructions
1. Insert your ignition key into the LeSabre's ignition and keep it in the OFF position.
2. Look under the dash and locate the Data Port. You will see two rows of slots, one above and one below. Starting from the top left, they are numbered 1 through 8 with the bottom left going from 9 to 16.
3. Locate slots 8 and 4 and, using the jumper wire, connect the metal pin 8 to the metal pin in 4.
4. Close the doors to the car and turn the ignition to the ON position or as far as you can go without actually starting the car. You will know when the ignition is in the correct position because the doors will automatically lock.
5. Press the LOCK and UNLOCK buttons at the same time for about 15 seconds. When the programming is complete, the doors will unlock and then lock again. These two buttons are now programmed.
6. Repeat the same process for any other buttons on the remote until all of the buttons are programmed within one minute of beginning the entire process.
7. Remove the electrical jumper wire from the data port.
Tags: jumper wire, buttons programmed, doors will, electrical jumper, electrical jumper wire