Solar panels can be small.
A solar cell converts light into electricity. When light shines on a photocell, it produces a tiny amount of voltage. The voltage produced by a single solar cell is very small, about 1/2 volt. This is too small to drive a load; therefore, a number of solar cells are connected in series to produce a higher voltage. A solar panel, consisting of a number of solar cells, can be used to drive a load, such as a light bulb. It is fairly simple to make a solar cell-driven light bulb for a science fair.
Instructions
1. Strip about 1 inch of insulation from each end of a 1-foot long, red insulated wire and a 1-foot long, black. This can be done with a wire stripper, or light a candle, hold the end of a wire in the flame for a few seconds, take it out and pull off the insulation piece using pliers. Don't touch the wire end with bare hands immediately because it will be fairly hot.
2. Identify a 3 V, 100 mA solar panel's positive and negative terminals. You should see two wires extending from the solar panel. In most cases, the positive wire is red and the negative wire is black, but colors may vary. Check the solar panel markings to identify the correct polarity. The negative polarity is the ground.
3. Strip 1 inch of insulation from each of the solar panel's two wires. Use the method you used previously.
4. Connect the solar panel's positive terminal wire to any one of the two wires of a 100-Ohm, 1/4-watt resistor. This can be done by holding both wires side by side and then twisting them together with fingers or pliers.
5. Connect the other end of the resistor with the 1-foot long, red wire. Do this by placing their ends side by side and twisting them together with fingers or pliers.
6. An LED's positive lead is longer than its negative lead.
Connect the red wire's other end to the longer lead (positive) of a light-emitting diode (LED). Use the method you used previously.
7. Connect the LED's shorter lead (negative) to the 1-foot long, black wire. Place the wire ends side by side and twist them together with fingers or pliers.
8. Connect the black wire's other end to one of the two leads of a small, push-button switch. Because push-button switch leads are very stiff, you can simply wind the black wire around the lead to make the connection.
9. Connect the push-button switch's other lead to the solar panel's negative (ground) wire. Use the method you used previously.
10. Press the switch's push button. This will light the LED. Do not keep the light on for more than a few seconds because it may burn the LED. You may push the button, however, as many times and as often as you want.
Tags: solar panel, 1-foot long, black wire, fingers pliers, method used, method used previously